52126282 - YOU MUST MATCH THIS! (Note: This listing is for the module only.)
• To get your part number your mechanic will need to hook up a scan tool to your obd and read the abs module. The part number is not on the actual abs module. Review pictures prior to purchase. We did picture a sticker we put on the unit ourselves.
• EBCM will require programming to your vehicle.

EBCM will replace the following part numbers on 2008 Jeep Wrangler models:

52126282 - Again, this is not on the abs module. Your mechanic will need to pull this information from a scan tool.

• Module will require programming to your vehicle.
• Prior to purchase please verify your wheel speed sensors are good or have been replaced and that your wiring harness has no breaks as both of these situations can set trouble codes. 

Module has been tested: Unit has power, communication, dynamic sensor high and low data along with no visible damage, rust or corrosion.

Please follow below for proper installation of module.
• Disconnect the negative terminal of the battery. Make sure the battery connector is not touching the battery post.
• Disconnect and remove module to be replaced. Make sure connector harness is clean and there are no broken wires. 
• Install and connect the replacement module. 
• Connect the negative terminal of the battery.
• Have module programmed to your vehicle by your mechanic. Have him also clear or reset all monitors.

This module carries a 3 month warranty from the date of purchase. Please keep a copy of your sales record which we will send with your order.